Chapter 5 – General Operation
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
13841 Rev A
108
1. From the PROPELLER BALANCE SETUP menu, press
START and press the CHG/ADD PROP CONFIG key.
2. When finished editing as in paragraph 5.4.1.4, press START
to advance to the PROP CONFIG 2 OF 2 menu. From
there, the edited configuration can either be saved under a
new name or removed. Note that the factory default
horsepower configurations cannot be removed.
3. From the SAVE CONFIG AS key the user can use the text
editing keys to save the configuration under any desired
name.
Alternate path for saving corrected configurations –
Sometimes the user may want to save the auto-corrected
configurations if they were effective. This alternate path allows a
? CHOOSE PROP CONFIG
► <Current confg name>
40.00 G/IPS @ 12:00
► CHG/ADD PROP CONFIG
► AUTO CORRECTION< ON>
if ok, push START
? PROP CONFIG 2 of 2
► SAVE CONFIG AS
[Current confg name]
► REMOVE CONFIG
if ok, push START
To Next Page
Loading...
Need help?
General
