Chapter 5 – General Operation
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
13841 Rev A
111
2. Use the Edit Aircraft ID screen (see below) to enter the
number of the propeller (1 for engine No. 1 and so on) to be
balanced, as well as the additional information required.
3. Press START. The first Balance Propeller Setup screen
displays again, showing all the information the user just
entered.
4. Go on to the next Balance Propeller Setup screen and enter
the necessary information, in the same way as the user would
for the Vibrex 2000.
5. When the user is ready to begin propeller balancing, press
START. A screen displays, with a message asking the user to
operate the propeller. This is the same screen and message
displayed by the Vibrex 2000. See Section 5.4.2 “Acquiring
Balance Readings” for details.
6. Proceed with running the propeller and acquiring balance
readings, in the same way as the user would for the Vibrex
2000.
7. When the user has finished balancing the current propeller,
begin the operation for the next propeller, in the same way as
= EDIT AIRCRAFT ID ==
► CURSOR LEFT
[
] ENG-[ 1 ]
► CURSOR RIGHT
► RESTORE/RESET FIELD
if ok, push START
To Next Page
Loading...
Need help?
General
