82 Xenon Ultra 196X Series User Guide
User-Specified Good Read Delay
If you want to set your own length for the good read delay, scan the barcode below,
then set the delay (from 0 - 30,000 milliseconds) by scanning digits from the
Programming Chart, beginning on page 309, then Save.
Trigger Modes
Manual Trigger
When in manual trigger mode, the scanner scans until a barcode is read, or until
the trigger is released. Two modes are available, Normal and Enhanced. Normal
mode offers good scan speed and the longest working ranges (depth of field).
Enhanced mode will give you the highest possible scan speed but slightly less
range than Normal mode. Enhanced mode is best used when you require a very
fast scan speed and don’t require a long working range. Default = Manual Trigger-
Normal.
Trigger Toggle
Trigger Toggle mode lets you quickly hit the trigger two or three times to put the
scanner into either imaging mode or centering mode, then toggle back to
scanning. So, like a double-click with a mouse, you can control what the next
scanner’s action will be. For example, you could double-press the trigger to go into
imaging mode, then the next trigger press takes the image. The scanner then
reverts to scanning mode. Use the following codes to configure what action you
would like the scanner to take when in Trigger Toggle mode.
User-Specified Good Read Delay
* Manual Trigger - Normal
Manual Trigger -
Enhanced
*Trigger Toggle Off
To Next Page
Loading...
