12 Xenon Ultra 196X Series User Guide
After the driver is downloaded, scan the following code to program the scanner to
emulate a regular RS232-based COM Port.
No extra configuration (e.g., baud rate) is necessary.
Note: If you scan the USB Serial barcode either with an older Honeywell serial driver, or no
driver installed, you may no longer be able to scan barcodes. If this happens, either
uninstall the older driver versions and install the latest driver, or delete the specific
device entry in Device Manager.
CTS/RTS Emulation
ACK/NAK Mode
High Speed USB
Note: High Speed USB is only available with cable CBL-500-120-S00-HS and must be
ordered separately.
USB Serial
CTS/RTS Emulation On
* CTS/RTS Emulation Off
ACK/NAK Mode On
* ACK/NAK Mode Off
* High Speed USB Off
To Next Page
Loading...
