Xenon Ultra 196X Series User Guide 119
LED Solid (No Flash)
Under normal operations, the scanner’s LED flashes once for a good read. You may
set the LED to remain on for a length of time after a good read instead of flashing.
Default = LED Solid Off (Resume Flash).
If you have scanned a barcode and don’t want to wait for the LED to turn off, press
the trigger a second time and the LED turns off. You can then scan the next
barcode.
Find My Volume Control
Note: This setting is not supported by the Xenon Ultra 1960h scanner.
When you press the Find My button on the base or Access Point (page button), the
scanners associated with that base or Access Point will begin beeping in response.
If you press the trigger on a scanner that is beeping in response, or press the Find
My button on the base or Access Point a second time, all associated scanners will
stop beeping. The following settings set the paging volume, independent of the
volume used when scanning barcodes. Default = Low.
* LED Solid Off
(Resume Flash)
LED Solid 1 Second
LED Solid 3 Seconds
LED Solid 5 Seconds
Find My Volume Off
* Find My Volume Low
To Next Page
Loading...
