Honeywell Xenon Ultra 1962h - Battery Recommendations; Safety Precautions for Lithium Batteries

Xenon Ultra 196X Series User Guide 41
Power is supplied to the scanner by a rechargeable battery that is integrated in the
scanner handle. Batteries are shipped only partially charged. The battery should be
charged for a minimum of 4 hours before initial use to ensure optimal
performance.
Battery Recommendations
• The battery is a lithium ion cell and can be used without a full charge, and can
also be charged without fully discharging, without impacting the battery life.
There is no need to perform any charge/discharge conditioning on this type of
battery.
• Keep the base connected to power when the host is not in use.
• Replace a defective battery immediately since it could damage the scanner.
• Avoid dropping the battery or device. If you suspect the battery and/or device is
damaged or if intermittent power and charging issues occur, send the relevant
device(s) to a Honeywell service center for inspection of the device and/or
battery.
• Although your battery can be recharged many times, it will eventually be
depleted. Replace it after the battery is unable to hold an adequate charge.
• Batteries should be replaced periodically, typically two years depending on the
specific device.
• If you are not sure if the battery or charger is working properly, send it to
Honeywell International Inc. or an authorized service center for inspection.
Refer to Customer Support on page xvii for additional information.
Safety Precautions for Lithium Batteries
• To learn more about Battery Maintenance for Portable Devices, go to
honeywell.com/PSS-BatteryMaintenance.
• Do not place batteries in fire or heat the batteries.
• Do not store batteries near fire or other high temperature locations.
• Do not store or carry batteries together with metal objects.
• Do not expose batteries to water or allow the batteries to get wet.
• Do not connect (short) the positive and negative terminals, of the batteries, to
each other with any metal object.
• Do not pierce, strike or step on batteries or subject batteries to strong impacts or
shocks.
• Do not disassemble or modify batteries.
Caution: Use only Honeywell Li-ion battery packs, model number BAT-
SCN11 or BAT-SCN11WC, rated 3.7 Vdc, 7.4Whr in this device.
Use of any non-Honeywell battery may result in damage not
covered by the warranty.