Xenon Ultra 196X Series User Guide 39
Find My Button
When you press the Find My button on the base, the scanners associated with that
base will begin beeping (3 short and 1 long beep). If you press the trigger on a
scanner that is beeping in response, or press the Find My button on the base or a
second time, all associated scanners will stop beeping. See Find My Mode on page
48 for further information about Find My button settings.
Find My Button and Presentation Modes
When in Streaming Presentation Mode, the scanner’s aimer goes out after a short
time, but the scan illumination remains on all the time to continuously search for
barcodes (see Streaming Presentation Mode on page 91). When in Temporary
Streaming Presentation Mode, pressing the Find My button on the base puts the
scanner into Streaming Presentation Mode until the timeout occurs. If a barcode is
scanned before the timeout is reached, the timer starts over.
When the scanner is in the base, press the Find My button once to put the scanner
into Temporary Streaming Presentation Mode. When the scanner is in the base and
the base has external power (plugged into an outlet), press the Find My button
twice to put the scanner into Streaming Presentation Mode. Press it twice again to
end Streaming Presentation Mode. When the base does not have external power,
pressing the Find My button twice does not trigger Streaming Presentation Mode.
When the scanner is out of the base, the Find My button works normally. Default =
Temporary Streaming Presentation Mode On.
To remove Temporary Streaming Presentation Mode, scan the barcode for Find My
Mode On page 48.
* Temporary Streaming Presentation Mode
On
To Next Page
Loading...
