Xenon Ultra 196X Series User Guide 111
,
Multiple Symbols
When this programming selection is turned On, it allows you to read multiple
symbols with a single pull of the scanner’s trigger. If you press and hold the trigger,
aiming the scanner at a series of symbols, it reads unique symbols once, beeping
and or vibrating (if turned on) for each read. The scanner attempts to find and
decode new symbols as long as the trigger is pulled. The maximum number of
barcodes read is 128. When this programming selection is turned Off, the scanner
will only read the symbol closest to the aiming beam. Default = Off.
Multiple Symbols Count
The Multiple Symbol Count setting controls the number of barcodes the scanner
reads in one trigger pull while in Multiple Symbol mode. If the count is set to 0,
Multiple Symbols mode is turned off and the scanner will turn off until the trigger
is released. If the count is set to 1 or more, the scanner will turn off after the count
Good Read Beep - Each
Code in Sequence
* Good Read Click - Each
Code in Sequence
Good Read Beep - Partial
Sequence Output
* Error Tone - Partial
Sequence Output
On
* Off
To Next Page
Loading...
