Xenon Ultra 196X Series User Guide 121
Out-of-Range Delay
Note: This setting is not supported by the Xenon Ultra 1960h scanner.
When using the Out-of-Range Alarm settings, the length of the delay for the alarm
is set with an Out-of-Range Delay. When the scanner is out of range of the base or
Access Point, the alarm will delay for a set length of time before going off. Set the
length (in seconds) for a timeout by scanning the following barcode, then setting
the timeout (from 0-3,000 seconds) by scanning digits from the Programming
Chart, beginning on page 309, then Save. Default = No Delay.
Vibrate – Good Read
The scanner vibrates once when a barcode is successfully read, and twice when a
programming barcode is successfully read. When a programming barcode is
unsuccessful, the scanner emits one long vibration (2 times the Vibrate Duration
length). Scan Vibrate - Good Read Off to keep the scanner from vibrating. Default
= Vibrate - Good Read Off.
Scanner Alarm Volume
Medium
Base Alarm Volume
High
Scanner Alarm Volume
High
Out-of-Range Delay
* Vibrate- Good Read Off
Vibrate- Good Read On
To Next Page
Loading...
