Xenon Ultra 196X Series User Guide 59
Batch Mode Beep
When scanning in Inventory Batch Mode (page 59), the scanner beeps every time a
barcode is scanned. When Batch Mode Beep is On, you will also hear a click when
each barcode is sent to the host. If you do not want to hear these clicks, scan Batch
Mode Beep Off. Default = Batch Mode Beep On.
Batch Mode Storage
When a scanner is storing data during a Batch Mode process, you can select
whether the data is stored in Flash memory or in RAM.
Flash Storage: The scanner writes any untransmitted data to flash memory prior to
powering down. The data will still be there when the scanner powers back up.
However, the scanner will power down, even with untransmitted data, if it reaches a
power down timeout or if the battery or battery-free supercapacitor power is very
low.
RAM Storage: The scanner will not power down while it contains data that has not
been transmitted to the base or Access Point, even if it reaches a power down
timeout. However, if the scanner runs out of power, it will power down and the data
will be lost.
Default = Flash Storage.
Inventory Batch Mode
Persistent Batch Mode
Batch Mode Beep Off
* Batch Mode Beep On
* Flash Storage
To Next Page
Loading...
