Xenon Ultra 196X Series User Guide 5
Connect with RS232 Serial Port
1. Turn off power to the terminal/computer.
2. Connect the appropriate interface cable to the scanner.
Note: For the scanner to work properly, you must have the correct cable for your type of
terminal/computer.
Note: The power supply must be ordered separately, if needed.
3. Plug the serial connector into the serial port on your computer. Tighten the two
screws to secure the connector to the port.
4. Once the scanner has been fully connected, power up the computer.
This interface programs 115,200 baud, 8 data bits, no parity, and 1 stop bit.
Corded Scanner RS232 Serial Port Connection:
To Next Page
Loading...
