CHAPTER
5
Xenon Ultra 196X Series User Guide 115
HEALTHCARE SETTINGS
The following settings have been developed to enhance scanning in a healthcare
environment. These settings are only supported by the Xenon Ultra 1960h scanner
and the Xenon Ultra 1962h scanner and base. They allow you to set quickly
configure streaming presentation, and to set the scanner and base to quiet modes
for scanning that do not disturb resting patients.
Quiet Operations - Combination Codes
The following combination codes program your healthcare scanner and base for
silent or quiet settings using a single programming code. If you wish to program
some of these quiet settings individually, refer to Quiet Operations - LED and
Volume Settings, beginning on page 117.
Silent Mode with Flashing LED
Scan the following barcode to completely silence the scanner and base. The
scanner beep, base beep, base and scanner power up beep, and scanner linking
sounds are all silenced. When a barcode is scanned, the LED and aimer flash 5
times. Green indicates a good scan, red indicates a bad scan.
Silent Mode with Flashing LED -
Cordless Scanner and Base
Silent Mode with Flashing LED -
Corded Scanner
To Next Page
Loading...
