Xenon Ultra 196X Series User Guide 67
Reset the Factory Defaults: All Application Work Groups
The following barcode defaults all of the work groups to the factory default
settings.
To see what the factory default settings are, refer to the table of Menu Commands,
beginning on page 244. The standard product default settings for each of the
commands are indicated by an asterisk (*).
Note: Scanning this barcode also causes both the scanner and the base or Access Point to
perform a reset and become unlinked. The scanner must be placed in the base, or the
Access Point linking barcode must be scanned to re-establish the link. Refer to
Scanner Modes, page 51 for additional information.
If your scanner is in multiple scanner mode, you will hear up to 30 seconds of beeping
while all scanners are relinked to the base or Access Point and the settings are
changed.
Reset the Custom Defaults: All Application Work Groups
If you want the custom default settings restored to all of the work groups, scan the
Custom Product Default Settings barcode below. (If there are no custom defaults,
it will reset the work groups to the factory defaults.) See "Set Custom Defaults" on
page 7 for further information about custom defaults.
Note: Scanning this barcode also causes both the scanner and the base or Access Point to
perform a reset and become unlinked. The scanner must be placed in its base, or the
Access Point linking barcode must be scanned to re-establish the link. Refer to
Scanner Modes, page 51 for additional information.
If your scanner is in multiple scanner mode, you will hear up to 30 seconds of beeping
while all scanners are relinked to the base or Access Point and the settings are
changed.
Factory Default Settings:
All Work Groups
PAPDFT&
Custom Default Settings:
All Work Groups
To Next Page
Loading...
