Xenon Ultra 196X Series User Guide 49
Find My Pitch
When you press the Find My button on the base or Access Point, the scanners
associated with that base or Access Point will begin beeping (see Find My Mode on
page 48). You can set the pitch of the Find My beep for each scanner by scanning
one of the following barcodes. Default = Low.
Error Indicators
Beeper Pitch - Base Error
The base can be configured to beep at a particular pitch when an error occurs,
such as transmission problems to a host system. The beeper pitch codes modify
the pitch (frequency) of the error tone the base emits when there is an error. Default
= Low.
Find My Mode Off
* Low (1000 Hz)
Medium (3250 Hz)
High (4200 Hz)
* Low/Razz (250 Hz)
Medium (3250 Hz)
High (4200 Hz)
To Next Page
Loading...
