94 Xenon Ultra 196X Series User Guide
Activation Character
This sets the character used to trigger scanning when using Character Activation
Mode. On the ASCII Conversion Chart (Code Page 1252), page 298, find the hex
value that represents the character you want to use to trigger scanning. Scan the
following barcode, then use the Programming Chart to read the alphanumeric
combination that represents that ASCII character. Scan Save to finish. Default = 12
[DC2].
End Character Activation After Good Read
After a barcode is successfully detected and read from the scanner, the
illumination can be programmed either to remain on and scanning, or to turn off.
When End Character Activation After Good Read is enabled, the illumination
turns off and stops scanning after a good read. If you scan Do Not End Character
Activation After Good Read, the illumination remains on after a good read.
Character Activation Timeout
You can set a timeout for the length of time the illumination remains on and
attempting to decode barcodes when using Character Activation Mode. Set the
length (in milliseconds) for a timeout by scanning the following barcode, then
setting the timeout (from 1-300,000 milliseconds) by scanning digits from the
Programming Chart, beginning on page 309, then Save. Default = 30,000 ms.
Activation Character
Do Not End Character
Activation After Good Read
End Character Activation After
Good Read
Character Activation Timeout
To Next Page
Loading...
