40 Xenon Ultra 196X Series User Guide
Temporary Streaming Presentation Timeout
Set a timeout for the length of time the illumination remains on and searching for
barcodes when using Temporary Streaming Presentation Mode. Set the length for
the timeout by scanning one of the barcodes below. Default = 10,000 ms (10
seconds).
Presentation Mode in the Base
Charge Information
The battery or battery-free supercapacitor is designed to charge while the scanner
is positioned in the cordless base unit. Refer to Scanner Communication and
Scanning, page 42, for an interpretation of the Charge Status indicators. Refer to
Charge Only Mode (page 51) if you need to charge a scanner without linking it to
the base.
Place the scanner in the base that is connected to an appropriate power supply.
Use only a Listed Limited Power Source (LPS) or Class 2 type power supply with
output rated 5 to 5.2Vdc, 1A.
Note: If you are powering the base through the interface cable (for example, a USB cable)
and not using an external power supply plugged into the aux port, the current
available for charging is reduced and charge times are increased.
Battery Information
*10 Second Timeout
30 Second Timeout
* Disabled
Enabled
To Next Page
Loading...
