176 Xenon Ultra 196X Series User Guide
UPC-E0
<Default All UPC-E Settings>
UPC-E0 On/Off
Most U.P.C. barcodes lead with the 0 number system. To read these codes, use the
UPC-E0 On selection. If you need to read codes that lead with the 1 number
system, use UPC-E1 (page 178). Default = On.
UPC-E0 Expand
UPC-E Expand expands the UPC-E code to the 12 digit, UPC-A format.
Default = Off.
UPC-E0 Addenda Required
When Required is scanned, the scanner will only read UPC-E barcodes that have
addenda. Default = Not Required.
* UPC-E0 On
UPC-E0 Off
On
* Off
Required
* Not Required
To Next Page
Loading...
