Xenon Ultra 196X Series User Guide 93
2D Reread Delay
Sometimes 2D barcodes can take longer to read than other barcodes. If you wish to
set a separate Reread Delay for 2D barcodes, scan one of the programming codes
that follows. 2D Reread Delay Off indicates that the time set for Reread Delay is
used for both 1D and 2D barcodes. Default = 2D Reread Delay Off.
Character Activation
You may use a character sent from the host to trigger the scanner to begin
scanning. When the activation character is received, the scanner continues
scanning until either the Character Activation Timeout (page 94) is reached, the
deactivation character is received (see Deactivation Character on page 95), or a
barcode is transmitted. Scan the On barcode to use character activation, then use
Activation Character (page 94) to select the character you will send from the host
to start scanning. Default = Off.
* 2D Reread Delay Off
Short (1000ms)
Medium (2000ms)
Long (3000ms)
Extra Long (4000ms)
* Off
On
To Next Page
Loading...
