Xenon Ultra 196X Series User Guide 289
Replace Cables and Batteries in Cordless Systems
Replace an Interface Cable in a Base
1. Turn the power to the host system OFF.
2. Disconnect the base’s cable from the terminal or computer.
3. Turn the base upside down.
4. Pull the connector out while maintaining pressure on the connector release
clip.
5. Replace with the new cable. Insert the connector into the opening and press
firmly. The connector is keyed to go in only one way, and will click into place.
Change a Contact Battery or Battery-Free Supercapacitor
1. Remove the screw on the bottom of the scanner with a T10 torx. Keep the screw
nearby.
Presentation CCB
Horizontal CCB
To Next Page
Loading...
