Xenon Ultra 196X Series User Guide 101
encountered. Scan the barcode below, then set the delay (from 1-3,000
milliseconds) by scanning digits from the Programming Chart, beginning on page
309, then Save. Default = 500 ms.
Preferred Symbology Default
Scan the barcode below to set all Preferred Symbology entries to their default
values.
Output Sequence Overview
Output Sequence Editor
This programming selection allows you to program the scanner to output data
(when scanning more than one symbol) in whatever order your application
requires, regardless of the order in which the barcodes are scanned. You can define
up to 15 barcodes in an output sequence.
Note: To make Output Sequence Editor selections, you’ll need to know the code I.D., code
length, and character match(es) your application requires. Use the alphanumeric
symbols from the Programming Chart, beginning on page 309. You must hold the
trigger while reading each barcode in the sequence.
To Add an Output Sequence
An output sequence is created using a string of serial commands that is sent to the
scanner. This string is most easily sent to the scanner using the EZConfig software
tool (see EZConfig for Scanning Introduction on page 237). You can also
accomplish this by scanning alphanumeric barcodes (see the Programming Chart,
beginning on page 309).
1. If you are using barcodes to create your output sequence, scan Enter Output
Sequence on page 105.
2. Code I.D.
On the Symbology Charts on page 295, find the symbology to which you want
to apply the output sequence format. Make a note of the hex value for that
symbology. If you are using barcodes to create your output sequence, scan the
2 digit hex value from the Programming Chart, beginning on page 309.
Preferred Symbology Time-out
Preferred Symbology Default
To Next Page
Loading...
