Xenon Ultra 196X Series User Guide 65
You may also scan the Scanner Name barcode below and scan a number for the
scanner name. For example, if you wanted to name the linked scanner “312,” you
would scan the barcode below, scan the 3, 1, and 2 barcodes on the Programming
Chart, beginning on page 309, then Save. Scan the Reset barcode and wait for the
scanner to relink to the base.
Application Work Groups
Your cordless, battery system can have up to 7 scanners linked to one base or
Access Point. You can also have up to 7 work groups. Your cordless, battery-free
supercapacitor system can have up to 3 scanners linked to one base or Access
Point. You can also have up to 3 work groups.If you want to have all of the scanners’
settings programmed alike, you don’t need to use more than one work group. If you
want each scanner to have unique settings (e.g., beeper volume, prefix/suffix, data
formatter), then you may program each scanner to its own unique work group and
may program each scanner independently. For example, you might want to have
multiple work groups in a retail/warehouse application where you need to have
different data appended to barcodes used in the warehouse area versus the retail
area. You could assign all the scanners in the retail area to one work group and
those in the warehouse to another. Consequently, any desired changes to either the
retail or warehouse area would apply to all scanners in that particular work group.
0003
0004
0005
0006
0007
Reset
Scanner Name
To Next Page
Loading...
