Xenon Ultra 196X Series User Guide 89
When the trigger is initiated, barcode history is not forgotten, and the Reread Delay
runs only during the scan session.
In-Stand Sensor Mode
This feature senses when the scanner is removed from the stand and tells it to
begin manual triggering. When Sensor On is enabled, the scanner defaults to
Manual Trigger Mode when it is removed from the stand. Default = Sensor On.
Note: If you are taking images (see Imaging Commands beginning on page 215), you must
set the In-Stand Sensor to Off.
Poor Quality Codes
Poor Quality 1D Codes
This setting improves the scanner’s ability to read damaged or badly printed linear
barcodes. When Poor Quality 1D Reading On is scanned, poor quality linear
barcode reading is improved, but the scanner’s snappiness is decreased, making it
less aggressive when reading good quality barcodes. This setting does not affect
2D barcode reading. Default = Poor Quality 1D Reading Off.
* Do Not Forget History, Run
During Scan Session
* Sensor On
Sensor Off
Poor Quality 1D Reading On
* Poor Quality 1D Reading Off
To Next Page
Loading...
