Xenon Ultra 196X Series User Guide 95
Character Deactivation
If you have sent a character from the host to trigger the scanner to begin scanning,
you can also send a deactivation character to stop scanning. Scan the following On
barcode to use character deactivation, then use Deactivation Character
(following) to select the character you will send from the host to terminate
scanning. Default = Off.
Deactivation Character
This sets the character used to terminate scanning when using Character
Deactivation Mode. On the ASCII Conversion Chart (Code Page 1252), page 298,
find the hex value that represents the character you want to use to terminate
scanning. Scan the following barcode, then use the Programming Chart, beginning
on page 309 to read the alphanumeric combination that represents that ASCII
character. Scan Save to finish. Default = 14 [DC4].
Illumination Lights
If you want the illumination lights on while reading a barcode, scan the Lights On
barcode, below. However, if you want to turn just the lights off, scan the Lights Off
barcode. Default = Lights On.
Note: This setting does not affect the aimer light. The aiming light can be set using Aimer
Mode (page 96).
* Off
On
Deactivation Character
* Lights On
Lights Off
To Next Page
Loading...
