Honeywell Xenon Ultra 1962h - Page 268

Xenon Ultra 196X Series User Guide 249
RS232 Handshaking *RTS/CTS Off 232CTS0 31
Flow Control, No Timeout 232CTS1 30
Two-Direction Flow Control 232CTS2 30
Flow Control with Timeout 232CTS3 31
RS232 Timeout (1-5100
milliseconds)
232DEL#### 31
*XON/XOFF Off 232XON0 31
XON/XOFF On 232XON1 31
*ACK/NAK Off 232ACK0 32
ACK/NAK On 232ACK1 32
Scanner-Bioptic Packet Mode *Packet Mode Off 232PKT0 32
Packet Mode On 232PKT2 32
Scanner-Bioptic ACK/NAK Mode *Bioptic ACK/NAK Off 232NAK0 33
Bioptic ACK/NAK On 232NAK1 33
Scanner-Bioptic ACK/NAK Timeout ACK/NAK Timeout (1-30000
milliseconds) *5100
232DLK##### 33
Cordless System Operation
Replace a Linked Scanner Override locked Scanner (Single
Scanner)
BT_RPL1 36
Temporary Streaming Presentation
Mode
*Temporary Streaming
Presentation Mode On
BEPPGE2 39
*10 Second Timeout TRGTPM10000 40
30 Second Timeout TRGTPM30000 40
Presentation Mode in Base *Disabled BT_PIB0 40
Enabled BT_PIB1 40
Base Power Communication
Indicator
*On :*:BASRED1 43
Off :*:BASRED0 43
Battery LED Alerts
Always Off BTRLED0 44
Always On BTRLED1 44
Always On in Base BTRLED4 44
Low Power Alerts *Low Power Alert 10% LPIRG210 45
Low Power Alert 20% LPIRG220 45
Low Power Alert 30% LPIRG230 45
Low Power Alert Flash Number (1-
9) *3
LPIFNO# 45
Interval Between Flashes (1-9) *2 LPIFDL# 46
Low Power Alert Repeat (1-5) *1 LPI_NO# 46
Interval Between Alerts (10-120)
*10
LPI_DL### 46
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page