Honeywell Xenon Ultra 1962h - Page 289

270 Xenon Ultra 196X Series User Guide
Digimarc Barcode Decoder Attempts (0-10) *3 DIGSTR## 202
Off DIGENA0 202
On DIGENA1 202
Uses ID Decoder then Both
Decoders
DIGENA2 202
*Uses Digimarc Decoder then
Both Decoders
DIGENA3 202
Uses ID Decoder then Alternates
Decoders
DIGENA4 202
Uses Digimarc Decoder then
Alternates Decoders
DIGENA5 202
Data Matrix Default All Data Matrix Settings IDMDFT 202
*On IDMENA1 202
Off IDMENA0 202
Direct Part Marking (DPM)
Decoding
Dotpeen DPM Decoding DPMENA1 204
*Disable DPM Decoding DPMENA0 204
Reflective (Etched) DPM
Decoding
DPMENA2 204
Data Matrix Msg. Length Minimum (1-3116) *1 IDMMIN#### 204
Maximum (1-3116) *3116 IDMMAX#### 204
Data Matrix Code Page Data Matrix Code Page (*51) IDMDCP## 204
MaxiCode Default All MaxiCode Settings MAXDFT 205
On MAXENA1 205
*Off MAXENA0 205
MaxiCode Msg. Length Minimum (1-150) *1 MAXMIN### 205
Maximum (1-150) *150 MAXMAX### 205
Aztec Code Default All Aztec Code Settings AZTDFT 206
*On AZTENA1 206
Off AZTENA0 206
Aztec Code Msg. Length Minimum (1-3832) *1 AZTMIN#### 206
Maximum (1-3832) *3832 AZTMAX#### 206
Aztec Append *On AZTAPP1 206
Off AZTAPP0 206
Aztec Code Page Aztec Code Page (*51) AZTDCP## 207
Chinese Sensible (Han Xin) Code Default All Han Xin Code Settings HX_DFT 207
On HX_ENA1 207
*Off HX_ENA0 207
Chinese Sensible (Han Xin) Code
Msg. Length
Minimum (1-7833) *1 HX_MIN#### 208
Maximum (1-7833) *7833 HX_MAX#### 208
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page