HP 4155A Programmer's Guide

HP 4155A/4156A SCPI Programming
Other Programming Tips
Auto-loading of Files
The HP 4155A/56A can automatically load les when it is turned on.
INIT les for Initial Settings.
If any setup les named INIT.MES , INIT.STR , INIT.CST ,or INIT.DAT
are on the diskette (in the built-in drive) when the HP 4155A/56A is turned
on, the HP 4155A/56A automatically loads these setup les to be the initial
settings.
This function saves you the trouble of getting application les every time you
turn on the HP 4155A/56A.
INIT.MES and INIT.DAT les
INIT.MES and INIT.DAT both contain measurement setup data. If both these les exist on
the diskette, the HP 4155A/56A gets INIT.DAT , not INIT.MES .
MEM no Files.
If any les named MEM no . DAT , MEM no . MES ,or MEM no . STR are on the diskette
in the drive, the les are automatically loaded from diskette to internal
memory when HP 4155A/56A is turned on. Where MEM no means MEM1 , MEM2 ,
MEM3 ,or MEM4 , which correspond to the four internal memory areas.
If the same internal memory is specied by multiple les (for example,
MEM1.MES and MEM1.DAT ), the priority is as follows:
1. DAT
2. MES
3. STR
IBASIC Program File to Auto-execute.
If an IBASIC program is stored in a le named \AUTOST" on the diskette in
the built-in drive, the program is automatically loaded and started when you
turn on the HP 4155A/56A.
4-49

HP 4155A Specifications

General

Brand	HP
Model	4155A
Category	Measuring Instruments
Language	English