HP 4155A Programmer's Guide

Programming: Measurement Setup
To set up a measurement, you can use SCPI commands to set the setup pages
of HP 4155A/4156A the same way that you can by interactive operation.
Basically, there are the following three ways to set up a measurement via
SCPI programming:
 Load the measurement setup data from diskette or internal memory.
Load the measurement setup data by SCPI programming. The data
was previously dened and stored to a diskette le or internal memory
interactively or by SCPI programming.
 Load the measurement setup data, then change some of the settings
.
Load the measurement setup data from diskette or internal memory
, then
change desired settings by SCPI programming.
 Set all settings.
Set all settings for measurement setup by SCPI programming.
This section describes the following tasks:
 To set or change setup data values.
 To read setup data values
To load previously dened measurement setup data, refer to \Programming:
File Operation".
4-8

HP 4155A Specifications

General

Brand	HP
Model	4155A
Category	Measuring Instruments
Language	English