HP 4155A Programmer's Guide

HP 4155A/4156A SCPI Programming
Programming: Measurement Setup
To Set or Change HP 4155/56 Setup Data Values
1. Send :PAGE subsystem commands that correspond to the setup data
values that you want to change or set.
There is a command subsystem for each setup page as shown in Table 4-1.
Each command subsystem has commands for setting the setup data of the
corresponding setup page.
Table 4-1. :PAGE Subsystem Commands for Measurement Setup
Setup Page Command Subsystem
CHANNELS: CHANNEL DEFINITION :PAGE:CHANnels[:CDEFinition]
CHANNELS: USER FUNCTION DEFINITION :PAGE:CHANnels:UFUNction
CHANNELS: USER VARIABLE DEFINITION :PAGE:CHANnels:UVARiable
MEASURE: SWEEP SETUP :PAGE:MEASure[:SWEep]
MEASURE: SAMPLING SETUP :PAGE:MEASure:SAMPling
MEASURE: PGU SETUP :PAGE:MEASure:PGUSetup
MEASURE: MEASURE SETUP :PAGE:MEASure:MSETup
MEASURE: OUTPUT SEQUENCE :PAGE:MEASure:OSEQuence
DISPLAY: DISPLAY SETUP :PAGE:DISPlay[:SETup]
DISPLAY: ANALYSIS SETUP :PAGE:DISPlay:ANALysis
STRESS: CHANNEL DEFINITION :PAGE:STRess:[CDEFinition]
STRESS: STRESS SETUP :PAGE:STRess:SETup
4-9

HP 4155A Specifications

General

Brand	HP
Model	4155A
Category	Measuring Instruments
Language	English