Programming: Print/Plot Operation
For the print/plot operation, you can use :HCOpy subsystem commands.
This section describes the following tasks:
๎
To output setup data to printer/plotter
๎
To output graphics result data to printer/plotter
๎
To output list result data to printer/plotter
๎
To dump screen image to printer/plotter
๎
To save hardcopy image to diskette
Before performing above tasks, the following print or plot settings must be set
interactively or by remote commands.
We recommend that you save the following settings in a ๎le
, then load it
before printing or plotting.
๎
Interface information
Interface Setting Parameter Command
HP-IB printer address :SYST:COMM:GPIB:RDEV:ADDR
Serial baud rate (reception) :SYST:COMM:SER:BAUD
parity scheme (reception) :SYST:COMM:SER:PAR
stop bits (reception) :SYST:COMM:SER:SBIT
software pacing scheme (reception) :SYST:COMM:SER:PACE
baud rate (transmission) :SYST:COMM:SER:TRAN:BAUD
parity scheme (transmission) :SYST:COMM:SER:TRAN:PAR
stop bits (transmission) :SYST:COMM:SER:TRAN:SBIT
software pacing scheme (transmission) :SYST:COMM:SER:TRAN:PACE
4-31
To Next Page
Loading...
Need help?
General
