HP 4155A Programmer's Guide

Sample Application Programs
Electromigration
Customization
Measurement setup le is stored in \EM.MES" le on provided diskette.In
the EM.MES le, the following is set up.You can modify these settings in the
EM.MES le or your own le, then use the setup for your own application.
 Constant source setup
Units Output Compliance
SMU1 50 mA 20.002 V
 Sampling Parameters
Mode Initial interval No. of samples Total samp. time
Linear 1s 10001 AUTO
1
1 Initial interval 3 No. of samples
 Stop Condition
If the DUT voltage exceeds the specied threshold, measurement is
stopped.
Enable Delay Threshold
20 ms 20 V
6-23

HP 4155A Specifications

General

Brand	HP
Model	4155A
Category	Measuring Instruments
Language	English