HP 4155A Programmer's Guide

Using HP Instrument BASIC
Creating ASP-like IBASIC Programs
You need to specify a lename in this command.
At bottom of screen, enter fileName[,msus] is displayed, where msus
means the mass storage unit specier.You can specify ,DISK or ,MEMORY .
Default is ,DISK .
2. Type a setup le name.
10 EXECUTE ("GETSETUP 'ICBVBE.PRO' ")
File name must be in single quotations ( ' ). Then press 4
Enter
5 .
3.
Select
NNNNNNNNNNNNNNNNNNNN
SINGLE secondary softkey.
10 EXECUTE ("GETSETUP 'ICBVBE.PRO'")
20 EXECUTE ("SINGLE")
30
4.
Select
N
NNNNNNNNNNNNNNNNNNNNNNNNN
SAVEDATA secondary softkey.
10 EXECUTE ("GETSETUP 'ICBVBE.PRO'")
20 EXECUTE ("SINGLE")
30 EXECUTE ("SAVEDATA ")
5. Specify le name to which you want to save the measurement setup and
result data.
10 EXECUTE ("GETSETUP 'ICBVBE.PRO'")
20 EXECUTE ("SINGLE")
30 EXECUTE ("SAVEDATA 'BV1.DAT'")
40 END
Finally, type END as above.
Setup File
In EXECUTE ("GETSETUP ") , you can specify a .PRO or .MES le:
 .PRO les are setup les created by the HP 4145B. The HP 4155A/4156A can read .PRO les.
 .MES les are setup les created by the HP 4155A/4156A.
In EXECUTE ("SAVEDATA ") , you specify a .DAT le, which is a le for storing the setup
and measurement result data.
1-42

HP 4155A Specifications

General

Brand	HP
Model	4155A
Category	Measuring Instruments
Language	English