HP Designjet 1050c Service Manual

Service Tests and Utilities
4-31
HP DesignJets 1050C and 1055CM Printers Service Manual
12 The Printer will start to print the Printhead Alignment Pattern and
the following message will be displayed on the front panel:
13 Once the Printhead Alignment is completed, the following message
will be displayed on the front panel:
WARNING Since you have replaced the Tubes System, make sure that you
perform the Calibrations Backup (⇒ Page 5-19) in order to
backup the EEROM Data from the Electronics Module. Make
sure you select "Tubes Replaced" when performing the
Calibrations Backup.
Approximate
Aligning printheads
INK STARTUP
time remaining
x min xx sec
INK STARTUP
Printer startup
Press Enter to
Continue
has finished
To p
Enter
Back
↑
↓
Press Enter

HP Designjet 1050c Specifications

General

Print Technology	Thermal Inkjet
Maximum Print Resolution	1200 x 600 dpi
Number of Ink Cartridges	4 (Cyan, Magenta, Yellow, Black)
Media Types Supported	Coated, glossy, plain, film, vellum, translucent bond
Maximum Media Size	36 in (914 mm) roll
Ink Types	Dye-based
Connectivity	Parallel
Memory	64 MB
Hard Drive	Not available
Media Sizes Supported	A4, A3, A2, A1, A0, B4, B3, B2, B1, B0
Roll Width	24 in, 36 in
Operating Systems Supported	Windows 2000, XP
Power Requirements	100 to 240 VAC (+/- 10%), 50/60 Hz