HP Designjet 1050c Service Manual

HP No.80 Ink Supplies Troubleshooting
3-12
HP DesignJets 1050C and 1055CM Printers Service Manual
Ink Cartridge Status While Replacing
The printer can report the following status messages while the Ink
Cartridge is being replaced:
Faulty The ink cartridge is faulty and must be replaced, before you can
continue printing.
Reseat The ink cartridge is having continuity problems. Try reseating the
Ink Cartridge.
Wrong Model The ink cartridge is not recognized by the printer and needs to be
replaced before the printer can continue.
Unknown The ink cartridge installed is not approved and must be replaced by
a genuine HP No.80 Ink Cartridge.
NOTE The main actions for all 4 status messages is as follows:
1 Reseat the Ink Cartridge.
2 If reseating does not resolve the status message, replace the Ink
Cartridge.
3 If the Status messages continue to appear, even after replacing the
Ink Cartridge, replace the complete Tubes System ⇒ Page 8-53.

HP Designjet 1050c Specifications

General

Print Technology	Thermal Inkjet
Maximum Print Resolution	1200 x 600 dpi
Number of Ink Cartridges	4 (Cyan, Magenta, Yellow, Black)
Media Types Supported	Coated, glossy, plain, film, vellum, translucent bond
Maximum Media Size	36 in (914 mm) roll
Ink Types	Dye-based
Connectivity	Parallel
Memory	64 MB
Hard Drive	Not available
Media Sizes Supported	A4, A3, A2, A1, A0, B4, B3, B2, B1, B0
Roll Width	24 in, 36 in
Operating Systems Supported	Windows 2000, XP
Power Requirements	100 to 240 VAC (+/- 10%), 50/60 Hz