HP Designjet 1050c Service Manual

HP No.80 Ink Supplies Troubleshooting
3-7
HP DesignJets 1050C and 1055CM Printers Service Manual
The Front Panel Display
The front panel display has a dedicated area to report the status of
your HP No.80 supplies. There are two different screens:
n One screen displays information on the ink cartridges:
n The other screen displays information on the printheads and the
printhead cleaners.
n During normal operation the front panel displays the ink levels,
however if there is a printhead status message such as: monitor
for example see page 3-13, Printhead Status Messages While
Printing, the printhead message will take precedence. This is the
case until you replace the printhead. If you need to see the ink
levels when they are not being displayed you can use the ink
systems menu to check them.
Ready
MAGENTA
YELLOW
BLACK
CYAN
Ink
Very Low
Low
Printer Status
Ink Cartridge Status
Printing
MAGENTA
YELLOW
BLACK
CYAN
Printhead
OK
OK
OK
Monitor
QualityMonitor
Printer Status
Printhead Status

HP Designjet 1050c Specifications

General

Print Technology	Thermal Inkjet
Maximum Print Resolution	1200 x 600 dpi
Number of Ink Cartridges	4 (Cyan, Magenta, Yellow, Black)
Media Types Supported	Coated, glossy, plain, film, vellum, translucent bond
Maximum Media Size	36 in (914 mm) roll
Ink Types	Dye-based
Connectivity	Parallel
Memory	64 MB
Hard Drive	Not available
Media Sizes Supported	A4, A3, A2, A1, A0, B4, B3, B2, B1, B0
Roll Width	24 in, 36 in
Operating Systems Supported	Windows 2000, XP
Power Requirements	100 to 240 VAC (+/- 10%), 50/60 Hz