HP Designjet 1050c Service Manual

Troubleshooting
1-19
HP DesignJets 1050C and 1055CM Printers Service Manual
Service Configuration Print
The Service Configuration Print is a useful tool for troubleshooting
the Printer. The Service Configuration Print contains the following
information about the Printer:
n General Configuration
n Printhead Info.
n Cartridge Info.
n Operating Conditions.
n Calibrations.
n Maintenance.
n IIO Configuration.
How to Print the Service Configuration Print
1 Load media (Roll media or at least an A4 Sheet) into the Printer.
2 Once the message "Ready" is displayed on the front-panel, scroll to
the "Printer Setup Options" icon and press the Enter key.
3 Once inside the "Printer Setup Options" menu, use the Arrow keys
to scroll to the "Utilities" menu display and press the Enter key.
4 Once inside the "Utilities" menu, use the Arrow keys to scroll to the
"Test Prints" menu display and press the Enter key.
Ready
MAGENTA
YELLOW
BLACK
CYAN
Ink
Printer Setup Options
Printer setup options
Demos ...
Image quality ...
Device setup ...
Pen settings ...
Utilities ...
Top
Enter
Back
↑
↓
Press Enter
Utilities
Calibrations ...
Contrast ...
Display Contrast ...
Recover Printheads ...
Top
Enter
Back
↑
↓
Press Enter
Test Prints ...

HP Designjet 1050c Specifications

General

Print Technology	Thermal Inkjet
Maximum Print Resolution	1200 x 600 dpi
Number of Ink Cartridges	4 (Cyan, Magenta, Yellow, Black)
Media Types Supported	Coated, glossy, plain, film, vellum, translucent bond
Maximum Media Size	36 in (914 mm) roll
Ink Types	Dye-based
Connectivity	Parallel
Memory	64 MB
Hard Drive	Not available
Media Sizes Supported	A4, A3, A2, A1, A0, B4, B3, B2, B1, B0
Roll Width	24 in, 36 in
Operating Systems Supported	Windows 2000, XP
Power Requirements	100 to 240 VAC (+/- 10%), 50/60 Hz