HP Designjet 1050c Service Manual

Service Tests and Utilities
4-33
HP DesignJets 1050C and 1055CM Printers Service Manual
3. Set Asian PS Fonts
The purpose of this Service Utility is to select the Asian Fonts after
replacing the Electronics Module.
WARNING ALWAYS SET THE ASIAN FONTS AFTER REPLACING
THE ELECTRONICS MODULE.
NOTE If the customer is not using any internal Asian PS Fonts, then this
Service Utility is not necessary.
Set the Asian PS Font as follows:
1 In the Service Utilities submenu, scroll to "3. Set Asian PS Font"
and press Enter.
WARNING Make sure you select the correct Asian PS font. Once the first
PostScript file has been received by the Printer, the rest of the
Asian PS fonts will be deleted from the Electronics Module and
there will be no way to recover them.
2 A list of ALL the Asian PS Fonts will be displayed and you must
select the font that you require. Use the Up and Down arrow keys
and press Enter once the selection has been made.
To p
Enter
Back
↑
↓
Press Enter
Service Utilities
4. Printer Model Type
5. Overdrive Cleaning
1. Tubes Purge
2. Release Info
3. Set Asian PS Font
Make Selection
To p
Enter
Back
↑
↓
Press Enter
3. Set Asian PS font
Korean...
Japanese ...
Chinese Traditional...
Chinese Simplified...
Make Selection

HP Designjet 1050c Specifications

General

Print Technology	Thermal Inkjet
Maximum Print Resolution	1200 x 600 dpi
Number of Ink Cartridges	4 (Cyan, Magenta, Yellow, Black)
Media Types Supported	Coated, glossy, plain, film, vellum, translucent bond
Maximum Media Size	36 in (914 mm) roll
Ink Types	Dye-based
Connectivity	Parallel
Memory	64 MB
Hard Drive	Not available
Media Sizes Supported	A4, A3, A2, A1, A0, B4, B3, B2, B1, B0
Roll Width	24 in, 36 in
Operating Systems Supported	Windows 2000, XP
Power Requirements	100 to 240 VAC (+/- 10%), 50/60 Hz