HP Designjet 1050c Service Manual

Service Calibrations
5-5
HP DesignJets 1050C and 1055CM Printers Service Manual
5 Use the Arrow keys to scroll through the "Service Calibrations"
selections.
6 Press the Enter key to begin a specific calibration when the
required Service Calibration is highlighted.
NOTE If the printer is not used for 3 minutes, the printer exits out of the
Service Calibrations Menu and you must repeat the above steps
to enter Service Calibrations again.
NOTE In some cases a quick press of a button may not be recognized by
the Printer. When pressing a button, be sure to press it
deliberately and all the way to the bottom of its travel.
NOTE If the Printer hangs up during an operation, switch the Printer
OFF and restart from step 1.
Service Calibrations
3. Service station...
2. Line sensor cal...
4. Roller mark position...
5. Pen to Paper Spacing...
1. Accuracy cal...

HP Designjet 1050c Specifications

General

Print Technology	Thermal Inkjet
Maximum Print Resolution	1200 x 600 dpi
Number of Ink Cartridges	4 (Cyan, Magenta, Yellow, Black)
Media Types Supported	Coated, glossy, plain, film, vellum, translucent bond
Maximum Media Size	36 in (914 mm) roll
Ink Types	Dye-based
Connectivity	Parallel
Memory	64 MB
Hard Drive	Not available
Media Sizes Supported	A4, A3, A2, A1, A0, B4, B3, B2, B1, B0
Roll Width	24 in, 36 in
Operating Systems Supported	Windows 2000, XP
Power Requirements	100 to 240 VAC (+/- 10%), 50/60 Hz