HP Designjet 1050c

System Error Codes
2-5
HP DesignJets 1050C and 1055CM Printers Service Manual
System Error: 010040
Problem
Description:
Error in Paper-axis Encoder quadrature.
Corrective Action: Try the following:
n Check that the Paper-Axis Motor cable is NOT broken or
damaged.
n Check that the Paper-Axis Motor cable is correctly connected.
n Replace the Paper-Axis Motor ⇒ Page 8-12.
n If the Error Code continues, replace the Electronics Module ⇒
Page 8-25.
WARNING Only replace one component at a time and check if the error has
gone before replacing another component. Using this procedure
you will be able to determine exactly which component failed.
System Error: 010041
Problem
Description:
Error in Scan-axis Encoder quadrature.
Corrective Action: Try the following:
n Check that the Encoder Strip is NOT broken or damaged.
n Replace the Encoder Strip ⇒ Page 8-34.
n Replace the Carriage Assembly ⇒ Page 8-44.
n If the Error Code continues, replace the Electronics Module ⇒
Page 8-25.
WARNING Only replace one component at a time and check if the error has
gone before replacing another component. Using this procedure
you will be able to determine exactly which component failed.