HP Designjet 1050c

System Error Codes
2-13
HP DesignJets 1050C and 1055CM Printers Service Manual
System Error: 0A0000
Problem
Description:
The Air Pressure is below the minimum requirement.
Corrective Action: Try the following:
n Check all the cables of the APS and make sure they are correctly
connected and are NOT damaged.
n Check all the tubes of the APS and Tubes System and make sure
they are correctly connected and are NOT pinched or damaged.
n Check that the Air Tube from the APS is correctly connected to
the Tubes System.
n Faulty APS Sensor, APS Valve or APS Pump. Replace the
complete APS ⇒ Page 8-20.
n Replace ONE Ink Cartridge at a time, checking if the error code
disappears.
WARNING Only replace one component at a time and check if the error has
gone before replacing another component. Using this procedure
you will be able to determine exactly which component failed.
System Error: 0A0010
Problem
Description:
Problem in Pressurizing the Air System.
Corrective Action: Try the following:
n Replace ONE Ink Cartridge at a time, checking if the error code
disappears.
n Check all the cables of the APS and make sure they are correctly
connected and are NOT damaged.
n Check all the tubes of the APS and Tubes System and make sure
they are correctly connected and are NOT pinched or damaged.
n Faulty APS Sensor, APS Valve or APS Pump. Replace the
complete APS ⇒ Page 8-20.
WARNING Only replace one component at a time and check if the error has
gone before replacing another component. Using this procedure
you will be able to determine exactly which component failed.