HP Designjet 1050c

System Error Codes
2-15
HP DesignJets 1050C and 1055CM Printers Service Manual
System Error: 0A0050 (Non-Continuable)
Problem
Description:
The Printer has detected a leak in the Tubes System before the life
of the System.
Corrective Action: Try the following:
n The leak detector could have been triggered due to condensation
in the Printer. Power OFF the Printer and allow the Printer to dry
for 15 minutes. Power ON the Printer and check if the error code
has disappeared.
n If the Error Code reappears, replace the complete Tubes System
(SRK) ⇒ Page 8-53.
WARNING Only replace one component at a time and check if the error has
gone before replacing another component. Using this procedure
you will be able to determine exactly which component failed.
System Error: 0A0060 (Non-Continuable)
Problem
Description:
The Printer has detected a leak in the Tubes System after the life of
the System.
Corrective Action: Try the following:
n The leak detector could have been triggered due to condensation
in the Printer. Power OFF the Printer and allow the Printer to dry
for 15 minutes. Power ON the Printer and check if the error code
has disappeared.
n If the error code reappears, replace the complete Tubes System
(SRK) ⇒ Page 8-53.
WARNING Only replace one component at a time and check if the error has
gone before replacing another component. Using this procedure
you will be able to determine exactly which component failed.