HP Designjet 1050c Service Manual

System Error Codes
2-17
HP DesignJets 1050C and 1055CM Printers Service Manual
System Error: 0C0032 (Continuable)
Problem
Description:
Drop Detector not Calibrated for all Printheads.
Corrective Action: Try the following:
n Perform the Service Station Calibration ⇒ Page 5-11.
n Replace the Drop Detector Assembly ⇒ Page 8-10.
n If the Error Code continues, replace the Electronics Module ⇒
Page 8-25.
WARNING Only replace one component at a time and check if the error has
gone before replacing another component. Using this procedure
you will be able to determine exactly which component failed.
System Error: 0C1000
Problem
Description:
Primer not Calibrated.
Corrective Action: Try the following:
n Perform the Service Station Calibration ⇒ Page 5-11.
n Make sure that the Primer Arm is not damaged. If the Primer
Arm is damaged, replace the Service Station ⇒ Page 8-8.
n Replace the Electronics Module ⇒ Page 8-25.
System Error: 0C1001
Problem
Description:
Primer Shutdown Error.
Corrective Action: Try the following:
n Check that the Primer Stepper-Motor Cable is NOT broken or
damaged and that the Primer arm moves freely from side to side.
n Replace the Service Station ⇒ Page 8-8.
n If the Error Code continues, replace the Electronics Module ⇒
Page 8-25.
WARNING Only replace one component at a time and check if the error has
gone before replacing another component. Using this procedure
you will be able to determine exactly which component failed.

HP Designjet 1050c Specifications

General

Print Technology	Thermal Inkjet
Maximum Print Resolution	1200 x 600 dpi
Number of Ink Cartridges	4 (Cyan, Magenta, Yellow, Black)
Media Types Supported	Coated, glossy, plain, film, vellum, translucent bond
Maximum Media Size	36 in (914 mm) roll
Ink Types	Dye-based
Connectivity	Parallel
Memory	64 MB
Hard Drive	Not available
Media Sizes Supported	A4, A3, A2, A1, A0, B4, B3, B2, B1, B0
Roll Width	24 in, 36 in
Operating Systems Supported	Windows 2000, XP
Power Requirements	100 to 240 VAC (+/- 10%), 50/60 Hz