HP LTO Ultrium - Page 117

DescriptionError
A shuttle tape command cannot be executed at this time.7412h
A Set Cartridge Type command cannot be executed at this time.7413h
A Set Mechanism Type command cannot be executed at this time.7414h
A Set Tension command cannot be executed at this time.7415h
A Set Speed command cannot be executed at this time.7416h
An Adjust Speed command cannot be executed at this time.7417h
A Set Position command cannot be executed at this time.7418h
The Cancel Set Position command cannot be executed at this time. Most likely because there
is no previous set position command active.
7419h
A Set Position and Speed command cannot be executed at this time.741Ah
A Servo Calibration command cannot be executed at this time.741Bh
An End of Tape Servo Calibration command cannot be executed at this time.741Ch
A Servo Initialization command cannot be executed at this time.741Dh
A Load Cartridge command cannot be executed at this time.741Eh
A Grab Leader Pin command cannot be executed at this time.741Fh
A Load and Grab leader pin command cannot be executed at this time.7420h
An Ungrab Leader Pin command cannot be executed at this time.7421h
An Unload cartridge command cannot be executed at this time.7422h
A Thread command cannot be executed at this time.7423h
An Unthread command cannot be executed at this time.7424h
A Recover Tape command cannot be executed at this time.7425h
A Head Clean command cannot be executed at this time.7426h
A Power-on Calibration command cannot be executed at this time.7427h
A Set Notify command cannot be executed at this time.7428h
A Wait Until Event command cannot be executed at this time, probably because the tape is
not moving.
7429h
A Set Head Position command cannot be executed at this time, probably because a servo
calibration is in progress.
742Ah
A Set Tracking Offset command cannot be executed at this time, probably because a servo
calibration is in progress.
742Bh
A DSP command to learn the VI offset is not allowed now because the tape is moving or
another task is in progress.
742Ch
Volume 1: hardware integration 117