DescriptionError
The thread operation is being retried because the pin detect sensor indicates parked when
not parked.
7686h
The threading recovery could not get the tape stopped in a reasonable time period.7687h
Timed out waiting for a regrab to complete before threading.7688h
Timed out trying to read the media manufacturer’s information.7689h
A faulty LP sensor has made it necessary to detect pin parking via FRM stall.768Ah
Attempt to park failed. An LP sensor was most likely asserted when it should not have been.768Bh
A VI cal was necessary to recover a DSP seek command failure. (This is a recovery algorithm.)768Ch
The FRM driver required a reset and was restarted. This is not a fault.768Dh
The BRM Driver required a reset and was restarted. This is not a fault.768Eh
The reel motor flex continuity check failed, the line is stuck high.768Fh
The reel motor flex continuity check failed, the line is stuck low.7690h
Unable to read the media manufacturers information from the LPOS bit stream.7691h
A full eject was invoked as part of a load fault recovery.7692h
Gently nudged grabber in order to help park leader pin. Information only, not a fault.7693h
Leader pin may have come ungrabbed. Regrabbing pin.7694h
A cartridge load as part of init failed.7695h
A special recovery to try to free a stuck LP sensor is in progress.7696h
The recovery effort to try to free a stuck LP sensor failed.7697h
The BRM over rotated during leader block demate in recover tape. Info only.7698h
The front reel motor DAC offset is too large or too small.7699h
The back reel motor DAC offset is too large or too small.769Ah
A forced eject command was invoked. This is not a fault.769Bh
The LPOS lock-up process 1 produced a value that does not pass the basic sanity check.769Ch
The LPOS lock-up process 2 produced a value that does not pass the basic sanity check.769Dh
The removing slack operation timed out while trying to determine the best direction for recov-
ery.
769Eh
The radii estimation process in recover tape yielded a negative result.769Fh
Unable to send a DspSetGen command.
76A0h
Failed to complete a SetGen command.
76A1h
Empty Dsp interrupt.76A2h
Drive error codes128
To Next Page
Loading...
