DescriptionError
No default WWN. Used by the WWN module.9455h
No current WWN. Used by the WWN module.9456h
WWN not changed.9457h
No default value for the WWN. Used by the WWN module.9458h
Library check condition surrogate SCSI command. Used in surrogate SCSI to cause the siS-
etScsiStatus to set task SCSI status to 2.
9459h
Insufficient registration resources. Used in Fibre Channel when the maximum number of
WWN has been reached.
945Ah
Write inhibit caused by suspect integrity.945Bh
Busy command during LU Reset. This command should receive BUSY during the resetting of
the LU.
945Ch
Operation complete.945Dh
The maximum number of bridge LUNs has been reached.945Eh
Unit Attention condition has been detected for this initiation to the SMC LUN.945Fh
The remote SMC device server is in the Not Ready state.9460h
The Bridging Mode Sense cache has become corrupt due to a firmware defect.9461h
The Bridging Mode Sense cache is full, caching operation failed.9462h
Unable to forward command to the automation device because the ADT port is logged out.9463h
Used to instruct the Bridge Device server to resend a SCSI command to the remote SMC LUN.9464h
Cleaning cartridge is seated but not threaded.9465h
Firmware upgrade cartridge is seated but not threaded.9466h
Invalid value in supplied drive serial number.9467h
siCheckWWN has detected that the supplied WWN is already assigned.
9468h
Tagged overlapped command.9469h
Returned GOOD status.946Ah
Lock SMC cache failed. Internal return status indicating the SMC cache was not locked.946Bh
SMC cache locked. Reported is siSmcLockCache() is called when the cache is not unlocked.946Ch
Bridge ready but operation in progress. The Bridging Manager is busy. It already has an
open exchange with the remote SMC device server.
946Dh
Bridge not ready and operation in progress. The Bridging Manager is busy. It already has
an open exchange with the remote SMC device server.
946Eh
Invalid Vendor ID.946Fh
Volume 1: hardware integration 139
To Next Page
Loading...
