DescriptionError
Invalid Product ID.9470h
Medium removal prevented.9471h
Forward task to drive. Not a reportable error code.9472h
Logout in bad state. The Bridging Manager received notification of an ADT port Logout while
waiting for TMF response to abort synchronizing PAMR command.
9473h
Not reserved. If the OIR bit is set in Device Config mode page, commands will return this if
there is no persistent reservation.
9474h
Initialization in progress. The Automation Controller is initializing the drive.9475h
Invalid field in medium attribute. An invalid field is the SCSI Set Medium Attribute command
parameter list.
9476h
Truncated medium attribute. A medium attribute in a SCSI Set Medium Attribute parameter
list is truncated.
9477h
Invalid field in Log Data cache. An invalid field in the SCSI Set Log Data Cache command
parameter list.
9478h
Truncated log page descriptor. A log page descriptor in a SCSI Set Log Date Cache command
is truncated.
9479h
Invalid field in parameter list.947Ah
Invalid field in SP Out data.947Bh
SP Out parameter list length error in CDB.947Ch
Data encryption parameters changed by another initiator Unit Attention.947Dh
Data encryption parameters changed by vendor specific event Unit Attention.947Eh
SP Key instance CTR changed.947Fh
Unsupported encryption cartridge.9480h
Firmware upgrade already in progress. Another initiator has already started a FW download
sequence.
9481h
Firmware upgrade image not MOD4.9482h
Firmware upgrade image has bad CS on first chunk.9483h
Firmware upgrade reboot in progress.9484h
The boot info area of the serial flash is corrupt. EnFUG command set will not work.9485h
No key is available when asked to encrypt or decrypt.9486h
SetManagementURI command is only allowed when the drive is not ready.
9487h
Parameter list length specified has too many URI descriptors. Only used with the SetManage-
mentURI command.
9488h
Logical EOT has been detected.9489h
Drive error codes140
To Next Page
Loading...
