DescriptionError
Decrypt key fail limit reached. Exhaustive search attack prevention.948Ah
Stored HAT count in NV is greater than Max HAT Retries.948Bh
Stored default Map ID for this port is invalid.948Ch
Write command allocation length error. If encryption mode is set to encrypt, only 8 MB record
size is allowed.
948Dh
Too many stalled auto mode commands already exist in the slow device server queue.948Eh
The drive has detected invalid sense data from the remote SMC device server.948Fh
KMS did not provide a key.9490h
Parameter list length error in the CDB.9491h
A command descriptor in the Set Snapshot Command Set parameter list was truncated.9492h
The configuration descriptor in the Set Snapshot Config parameter list was truncated.9493h
Failed to start the Service Buffer snapshot because one is already in progress.9494h
SI RSA Signature Known Answer Test has failed.9495h
Cannot set security parameters, the drive has been (externally) configured not to accept se-
curity parameters.
9496h
KMS reported it failed to obtain security parameters, without which the command cannot be
executed.
9497h
KMS reported it failed to obtain security parameters, unrecoverable error.9498h
KMS reported it failed to obtain security parameters; error when trying to access the key.9499h
KMS reported it failed to obtain security parameters, key not found.949Ah
KMS reported it failed to obtain security parameters, incorrect key.949Bh
Timer expired when waiting for security parameters from KMS.949Dh
Encryption UA.949Eh
KMS reported it failed to obtain security parameters, request not authorized (for example,
the loaded tape is not encryption capable).
949Fh
The drive is in a special maintenance or self-test mode.94A0h
The parameter list of a SET LIVE TRACE POINTS/VARIABLES command was truncated.94A1h
The parameter data of a SET TIMESTAMP command was truncated.94A2h
Timestamp changed UA.94A3h
Failed to initiate an SPI transfer to read an STTF log from flash memory.94A4h
The parameter data of a SET SERVICE LOCATION command was truncated.94A5h
Cannot enable an NPIV port when the physical port is in Loop mode.94A6h
Volume 1: hardware integration 141
To Next Page
Loading...
