HP LTO Ultrium User Manual

DescriptionError
The parameter data of a SET PREVENT MEDIUM REMOVAL command was truncated.94A7h
The device server does not have sufficient recourses to process all the initiators in the para-
meter list.
94A8h
SET PREVENT MEDIUM REMOVAL command not allowed when SMC LUN enabled.94A9h
SET PREVENT MEDIUM REMOVAL command not allowed when an NPIV is not associated
with the SMC logical unit.
94AAh
SET LEGACY RESERVATION command not allowed when SMC LUN enabled.94ABh
SET LEGACY RESERVATION command not allowed when an NPIV is not associated with
the SMC logical unit.
94ACh
The parameter data of a SET LEGACY RESERVATIONS command was truncated.94ADh
The parameter data of a SET PERSISTENT RESERVATIONS command was truncated.94AEh
The device server does not have sufficient recourses to process all the reservation keys in the
parameter list.
94AFh
Error detected in an SP OUT command or its data, either when attempting to establish a
CCS, or after decrypting when the integrity is checked.
94B0h
Error detected in an SP OUT command Authentication step; SAI_AC or SAI_DS is wrong.94B1h
Error detected in an SP OUT command Authentication step; authentication failed.94B2h
A host tried to initiate a new SA while another is in progress.94B3h
The creation of a SA is in progress, the command is not allowed.94B4h
FUGImage too large for flash.94B5h
The bridging manager has attempted to send a SCSI command to the remote SMC LUN before
the bridging port has been registered or configured.
94B6h
A Cryptographic Algorithm function returned an unexpected length.94B7h
The Set Beacon LED Config parameter list is truncated.94Bh8
No task objects available in the SCSI Task Manager. This is a fatal error.94B9h
The Set IP Config parameter list is truncated.94BAh
A Certificate Manager function returned an unexpected length.94BBh
A Certificate Manager function returned an unexpected length on a Security Configuration
command.
94BCh
A Cryptographic Algorithm function returned an unexpected length on a Security Configuration
command.
94BDh
The SPOUT signature could not be authenticated because the Management Host Certificate
public key is not present.
94BEh
A Set Symbolic Name descriptor is truncated.94BFh
Drive error codes142

HP LTO Ultrium Specifications

General

Category	Tape Drive
Capacity (Compressed)	Up to 30 TB (LTO-8), Up to 45 TB (LTO-9)
Transfer Rate (Compressed)	Up to 900 MB/s (LTO-8), Up to 1000 MB/s (LTO-9)
Interface	SAS, Fibre Channel
Technology	Linear Tape-Open (LTO)
WORM Support	Yes
Encryption Support	Yes (AES 256-bit)
Partitioning Support	Yes
Capacity (Native)	Up to 12 TB (LTO-8), Up to 18 TB (LTO-9)
Transfer Rate (Native)	Up to 360 MB/s (LTO-8), Up to 400 MB/s (LTO-9)
Backward Read Compatibility	Yes (LTO-8 reads LTO-7, LTO-6; LTO-9 reads LTO-8, LTO-7)
Backward Write Compatibility	Yes (LTO-8 writes to LTO-7; LTO-9 writes to LTO-8)