DescriptionError
The acceleration phase of the seek did not complete within the allotted time.A008h
The deceleration phase of the seek did not complete within the allotted time.A009h
Settle window criterion was not met at the end of the deceleration phase of the seek.A00Ah
Hand-off to the tracking phase of the seek did not complete within the allotted time.A00Bh
Servo mode was not recognized during a seek.A00Ch
A timer fault occurred during a negative stiction pulse.A00Dh
A timer fault occurred during a positive stiction pulse.A00Eh
A timer fault occurred during the bottom crash stop calibration.A00Fh
A timer fault occurred during the top crash stop calibration.A010h
The measured actuator stroke size is too small.A011h
A timer fault occurred during TSB calibration.A012h
TSB0 calibration did not complete within the allotted time.A013h
TSB1 calibration did not complete within the allotted time.A014h
TSB2 calibration did not complete within the allotted time.A015h
TSB3 calibration did not complete within the allotted time.A016h
An invalid servo track number was specified for a seek.A017h
The calculated final target for a VI seek was out of range.A018h
The calculated final target for a Tape seek was out of range.A019h
Unable to find the requested TSB.A01Ah
Unable to find Servo code on the tape; bad head.A01Bh
Unable to identify the current Top Servo band.A01Ch
Unable to identify the requested Seek type.A01Dh
Unable to lock to tape when not tracking on VI.A01Eh
Unable to lock to tape servo code within the allotted time.A01Fh
Primary servo bump went out while writing.A020h
System ARM is not allowing tape servo operations.A021h
VI offset calibration has not been done.A022h
The specified servo scope mode is not valid.A023h
The specified servo scope channel bit width is not supported.A024h
The specified servo source number is not valid.A025h
Volume 1: hardware integration 147
To Next Page
Loading...
