DescriptionError
The specified servo scope trigger position is too large compared with the specified number
of data packets in the trace.
A026h
The specified servo scope source address was not found in the address array.A027h
The specified servo scope source bit size was not found in the size array.A028h
A Measure Servo Heads command did not complete within the allotted time.A029h
The main system ARM flagged the need to revert to VI.A02Ah
Band ID had good skew values from both bumps but was unable to identify the band.A02Bh
Band ID had good skew values from both bumps but identified different valid bands for each
bump.
A02Ch
Tape servo code available from at least one channel but unable to achieve tape lock. The
head is suspect.
A02Dh
Not enough good demod channels to attempt band ID whilst searching for tape servo during
TSB calibration.
A02Eh
Tape servo code available from at least one channel but unable to achieve tape lock. The
head is suspect.
A02Fh
The servo command is incorrectly formatted.A030h
The servo command cannot be executed now.A031h
Servo fault.A032h
Servo fault.A033h
Servo fault.A034h
Servo fault.A035h
Servo fault.A036h
One or more of the command parameters are invalid.A037h
The servo command sent is not supported.A038h
The servo command sent is out of sequence.A039h
The mechanism interface did not respond within the allotted timeout, shutting down the reel
motors.
A03Ah
Init servo command already in progress.A03Bh
Write memory servo command already in progress.A03Ch
Read memory servo command already in progress.A03Dh
Set generation servo command already in progress.A03Eh
Set scope mode servo command already in progress.A03Fh
PCA diagnostic servo command already in progress.A040h
Drive error codes148
To Next Page
Loading...
