DescriptionError
Live statistics servo command already in progress.A041h
Seek command already in progress.A042h
Report TSBs servo command already in progress.A043h
Define Scope Sources servo command already in progress.A044h
Configure Oscillator servo command already in progress.A045h
Define Signal Nodes servo command already in progress.A046h
Calibrate VI Stroke servo command already in progress.A047h
Calibrate TSBs servo command already in progress.A048h
Report Servo Status servo command already in progress.A049h
Configure Test DACs servo command already in progress.A04Ah
Report Servo Configuration servo command already in progress.A04Bh
Measure Servo Heads servo command already in progress.A04Ch
Copy Memory Block servo command already in progress.A04Dh
Report Enum Address servo command already in progress.A04Eh
Set Compensator Coefficients servo command already in progress.A04Fh
Set Head Position Tuning Parameters servo command already in progress.A050h
Clean Head servo command already in progress.A051h
Accelerometer Self-Test servo command already in progress.A052h
TSB calibration routine did not complete within the alloted time.A053h
The servo interrupt flagged the need to revert to VI. Most likely cause is that the tape position
data went away while tracking.
A054h
The servo system attempted to recover the actuator to a known state.A055h
The mechanism revision was not recognized while trying to configure the compensator.A060h
Timer unavailable for motion to the top crash stop as part of a head-clean routine.A061h
Timer unavailable for motion to the bottom crash stop as part of a head-clean routine.A062h
Timer unavailable for motion to the bottom crash stop as part of a head-clean routine.A063h
Seek at the top crash stop during a head-clean.A064h
Seek at the bottom crash stop during a head-clean.A065h
Compensator configuration already set from the EEPROM content or a mechanism revision
parameter missing.
A066h
The specified head mode is not recognized.A067h
Volume 1: hardware integration 149
To Next Page
Loading...
